logo

Pinion Yokes Ford Rear Ends. We ship worldwide!

Don't dismiss Pinion Yoke sounds or the vibrations in your Ford it will cost you big money! Broken pinion yokes might cause oscillations, sound and bad ride experience, are hazardous additionally may damage other major parts or your own car or truck. Your driveshaft could fail a dangerous situation at freeway speed.

New Pinion Yokes are available for Ford differentials including: 7.5, 8.0, 8.8, 9.0, 9.75, 10.25 and 10.5 inch.

We can help you with your Ford Pinion Yoke Problems

{image.index}/{image.total}

Proven Force is an automotive drivetrain and driveline fabrication, warehouse, distribution center in addition installation service center for both cars and pickups. Located in Maple Grove, MN we've been in operation helping the Downtown Minneapolis area for over 37 year. We can assist you with your current Ford pinion yoke problems.

Replacing a pinion yoke or seal can be a little touchy the first time. It's important not to over tighten the pinion nut. The reason is that between the two pinion bearings is a spacer or crush sleeve. It's there to maintain a little preload on the bearings and hold the adjustment made by tightening the pinion nut.

ring pinion and yoke

Be very careful to install the appropriate Ford yoke

Don't mix up the front and rear axle yokes this will lead to destruction pinion seal and dripping fluid. Pinion yokes are usually durable components, however they are positioned underneath the car or truck and therefore are at the mercy of impact harm from obstructions and debris, typically occurs when off roading. Two different styles of yokes are available the U-bolt style and the strap and bolt style.

Once you take out the drive shaft universal from your pinion yoke you will need to take out the nut that holds the pinion yoke in place and remove the pinion yoke. You don't need to remove the rear axle housing from the vehicle to do this. We suggest you install a brand new pinion seal while you have it apart.

Quite often the pinion yoke is pressed on the pinion shaft firmly with an interference fit and will require a 2 jaw puller to remove it. If the damaged pinion yoke has damaged the splines on the pinion shaft (as demonstrated in the video below) you will have to replace every one of the parts in shown in the figure to the above left, new ring and pinion shaft they are offered as a set, new pinion yoke and seal, new ujoint, straps, ubolts nuts and or clips. Be sure to setup the ring and pinion together with the manufactures recommendations which includes preloading pinion bearings with the correct pressure on crush sleeve.

New Pinion Yokes are available the following Ford differentials 7.5, 8.0, 8.8, 9.0, 9.75 and 10.25 inch.

Diff Model Part Number Spline Count Spline Dia Inch Hub Dia Inch Thru Hole Inch C/L To End Inch Ujoint Series Notes
Your Cost
Ford 7.5 PT3101-282
28
1.218 1.812 1.252 1.985
N/A
3.500/4.250 BC flange with 2.000 pilot $43.88
Ford 8 PT3104-252
25
1.098 1.812 2.625 4.375
1310F
U-bolt type $65.48
Ford 8.8 PT3304-05
30
1.312 1.812 1.275 3.145
1330F
U-bolt type $54.58
Ford 8.8 PT3301-302
30
1.312 1.812 1.25 1.588
N/A
3.500/4.250 BC flange with 2.000 pilot $43.88
Ford 9 PT3104-28
28
1.218 1.812 2.425 4
1310
U-bolt type
$60.99
Ford 9 PT3104-28A
28
1.218 1.812 2.155 3.85
1310
U-bolt type / Billet aluminum / Includes u-bolts and spacer (if required)
NA
Ford 9 PT3104-28B
28
1.218 1.812 2.155 3.85
1310
U-bolt type / Billet steel / Includes u-bolts and spacer (if required)
$175.31
Ford 9 PT3304-06
28
1.218 1.812 2.425 4
1330F
U-bolt type
$60.99
Ford 9 PT3504-08
28
1.218 1.812 2.425 4
1350
U-bolt type
$54.58
Ford 9 PT3504-08B
28
1.218 1.812 2.155 4.1
1350
U-bolt type / Billet steel / Includes u-bolts and spacer (if required)
$189.90
Ford 9 PT3504-35B
35
1.515 2.125 2.1 4
1350
U-bolt type / Billet steel / Includes u-bolts and pinion nut
$189.90
Ford 9 PT3304-282
28
1.218 1.812 2.425 5
1330F
5" CL-END / U-bolt type
$120.03
Ford 9.75 PT3301-312
31
1.312 1.812 1.64 1.955
N/A
3.500/4.250 BC flange with 2.000 pilot
$43.88
Ford 10.25 PT3304-07
31
1.343 1.812 1.262 3.15
1330F
U-bolt type / Double check length thru the hole $54.58
Ford 10.25 PT3304-08
31
1.343 1.812 1.64 3.5
1330F
U-bolt type / Double check length thru the hole $54.58
Ford 10.25 PT3504-03
31
1.343 1.812 1.262 3.143
1350
Strap type / Double check length thru the hole $61.70
Ford 10.25 PT3504-09
31
1.343 1.812 1.64 3.5
1350
Strap type / Double check length thru the hole $77.71
Ford 10.5 PT3504-09
31
1.343 1.812 1.64 3.5
1350
Strap type $77.71
Ford 10.5 PT4104-03
31
1.343 1.812 1.64 3.525
1410
Strap type $77.71
Minimum order $25.00, Shipping and Handling Charges will be added.

Pinion Yoke Play can bee seen in the video blow. Thanks to ScarletOrangeMan this demonstrates worn out splines inside the pinion yoke, time to have it replaced.

 

Large Inventory of Ford Pinion Yokes and Driveline Accessories Ready to Ship

You will find there's large stock of pinion yokes, weld yokes, ujoints and other driveline parts both for rear wheel drive (RWD), 2WD and 4WD vehicles. We offer driveline components for Domestic, Japanese, Korean and European car or truck applications. We provide a variety original equipment drivetrain parts for automobiles and pickup trucks, we can offer heavy duty diesel driveshafts and parts for your pickup trucks, 10 wheeler and or 18 wheeler.

Free Ford Driveshaft and Driveline Technical Support

We offer free of charge tech support to help you out in figuring out the difficulties with your own vehicle. In case you are locating a noises or vibrations from the driveline let us assist you solve the issue and help you save some cash.

You will find a complete motor vehicle service center in Maple Grove, MN within the suburbs of Minneapolis and usually offer one day services. The next time you want a quality Pinion Yoke or Driveline give us a try 763-425-7474 or 800-444-0755 and allow us to assist saving some funds. Email questions to info@provenforce.com. Quality performance is the difference!